I downloaded the only package, from the library, I can find, where all the pins , looking from above, are assigned as per actual unit (eg with the 8 pins sticking out the bottom)
The problem i am having is that the package verification manager cannot find. It.
In the components list it states "U1\_ESP01\_NONE"
Footprint manager, shows one blank rectangular shape with 4 pins on left & right hand sides without any numbers & below Blue boxes with pin numbers and designations next to each other.
BUT I can't change anything here.............? and if I did ,i would not have a clew what to change......
I have built a prototype of this circuit, with the esp01 soldered to the board next to all the components and ALL Cu tracks on the bottom, so that the board is as thin as possible, and fits in a small plactic box.
A little help please :)
Chrome
68.0.3440.106
Windows
10
EasyEDA
5.6.15