Hi,
In my schematic, I add GND and VCC from the wiring tools. After adding GND and VCC when I create a PCB out of my schematic, I don't see any pads for the GND and VCC pins. Because of that, I had to create a single pad and use that at the points where GND and VCC were to be connected. This seems to be working, but am I doing something wrong that I ain't getting a pad by default for GND and VCC?
See attached schematic for reference.
![GND_VCC_issue.jpg](//image.easyeda.com/pullimage/jjgwpLLP5es87SsXVmeTG1NSUAHbVvlhlHRhw289.jpeg)
Regards,
Deepak
Electron
3.0.11
Windows
7
EasyEDA
5.9.42