In Orcad, I used to, There are PCB bus for identical model.
So, I can draw just one sch module like K[100...110] and then exist 10 model for PCB.
Is there same puntion in this program??
Yours faithfully
In Orcad, I used to, There are PCB bus for identical model.
So, I can draw just one sch module like K[100...110] and then exist 10 model for PCB.
Is there same puntion in this program??
Yours faithfully
It does support multi-sheet flat schematics.
You can draw a section of circuit then copy and paste it in your schematic or you can create a section of circuit then do:
Save As Module...
and then paste that into your schematic.
https://easyeda.com/forum/topic/Bus_across_schematics-1BvpGYgys
https://easyeda.com/forum/topic/How_do_you_connect_bus_wiring_tool-A93lDxP7p
https://easyeda.com/forum/topic/BUS-QuohbtL3l