I'm sitting here with a simple tactile button scheme connected to a 74HC165D. When i use W for wiring and connecting pins together I can still move the circuits and no wires follow. I am positive that they are connected as a black dot show and I have a 300% zoom with all circuits snapped to the grid. Still it is not working on some components and some work. Also when moving the component with the broken link a red dot still exist on another wire which I can delete by hand. That dot should be removed when the link was. If I draw a short wire between a tactile swith and a resistor the line (wire!) can be moved out of focus. I find this so frustrating waisting a lot of time trying to wiring because when I trying to convert to schematic PCB it complains that there are some unfinished nets, and I can't find them exept moving a component one by one and some wires does not follow. Also when formatting wires get broken. Do all components have to be placed on the grid to be able to wire them and not losing connection? The reason for asking is that if I formating, let say "Distribute Horizontally" they are not following the grid and i have to rewire but must turn of snap to be able to continue. Yes I have tested different grid and snap sizes but it makes no difference. Or is this application still not able to do such fundamental tasks?