Does EasyEDA offer v-scoring to a non-panelized board? If it is, how would I indicate this on the PCB? I'm trying to find a way to add  a v-score, both sides, to a PCB. I have a design that converts Character LCD pins to a ribbon cable. Some LCDs have 0.100" pitch, some have 0.050" pitch. I have both pitches on the same board, and it would be nice to be able to snap the board in half at the "CUT" line indicated in the picture. Is there a way to do this without panelizing the boards? Maybe use a groove as a board cutout and leave very little material at each end of the groove?