Hello,
Is there any way to add both a female terminal block and its male plug counterpart to schematics (even if the male plug is not used in the design per se) so that both are included in the Bill of Material for ordering?
For example, I am considering a terminal block _DB2ERC-3.81-4P-GN_ but I cannot find the male plug _DB2EK-3.81-4P-GN_, which I think is the appropriate male plug, in any library. If I use this terminal block, I have to make sure that I can get the matching plug.
Thank you.
Edge Chromium
102.0.1227.0
Windows
10
EasyEDA
6.5.1