BUG
Concise problem statement: On PCB, when using mm measurements, the grid and snap are not aligned to 0,0
Steps to reproduce bug:
Open a new PCB editor. It will come up in English units (in or mils)
Switch units to mm
Grid does not align with 0.0,0.0
Results:
Expected results:
Browser:
Thanks for the quick reply. The last time I tried it - since I sent the report, it worked. So it is apparently harder to reproduce than I thought.
If I see it again, I'll grab more info.
This was on Chrome on OS X Yosemite - Version 44.0.2403.130 (64-bit).
Okay, it happened again.
I opened a new PCB Library window and it came up in English units.
I changed to mm and it was okay, but the grid sizes were not what I wanted - 2.54mm
I changed the grid size and snap size to 2mm and the grid is wrong - see attached picture. The bold white lines are centered a 0,0.
Is this what we needed to know about mesopcb's browser from an earlier post?
This was on Chrome on OS X Yosemite - Version 44.0.2403.130 (64-bit).
Or do we need to know the version of Chrome too?
Could you try this in Firefox and see what happens?
Yes, that is the correct Chrome information.
I tried it in Firefox and I see the same result - the mm grid is not centered at 0,0.
Brand new interactions and interfaces. 
Easy to use and quick to get started. 
It seems no problem under my browser, can you give us a picture?