I created a PCB Lib diagram of a DTMF Shield part, with pins 1-10. I also created a symbol with the same pin designations. All but one of the pins are connected to the Arduino Nano or Vcc.
However, the top 2 pins, 9 and 10, are shown in the PCB layout with no blue lines to anything. I am also getting no errors. I checked to make sure that the wires were actually connected, by moving the device on the schematic to see if the wires would follow and stay connected, which they did.
What am I doing wrong?
Brand new interactions and interfaces. 
Easy to use and quick to get started. 
