Hi, This seems like a silly question but I've had a few attempts at switching to Pro from Std and each time I get put off by the difference in zoom speed when zooming with the mouse. It's much faster in Pro than Std and it makes it difficult to quickly navigate around the pcb in particular. In Std I can fairly quickly get to an area of interest, zoom in to make fine adjustments and then zoom back out again. In Pro I'm forever overshooting the zoom amount I'm aiming for. Is there a way to adjust the mouse zoom sensitivity to match Std? Many thanks for any pointers, and thank you for all the work that goes into providing EasyEda James