Hello
It would be nice if someone help me on the below issues i am getting in PCB Layout.
I have connected multinetlabels in my schematics and when iam doing the layout netlabels are not showed connected to the controller and connected to the netlabels only.
just for examlpe-- capacitor c1 & c2 is connected to 3.3vd,gnd & microcontroller on 23 & 146 pin nos. in schematics. But when i layout the PCB found that 23 & 146 pin nos. shown 3.3vd written on it. and c1 & c2 shown connected to 3.3vd & gnd only. Should i connect it to controller pins 23 & 146 also or it will automatically connect it. just chk the image and help me on it. I will appreciate your help.My circuit is connected with multilabels.
"Should i connect it to controller pins 23 & 146 also or it will automatically connect it."
It would help if you either make your project public and post the url to it here or at least post a screenshot of your PCB.
If you are using the autorouter then nets with the same netlabels will be connected by tracks.
If you route the board by hand then you must connect the nets using the Track tool by following the ratlines.