Hello,
I created a symbol defined by a sub-circuit, and I saved them in my MyParts library.
I checked that the symbol name and pins is the same as for the sub-circuit as detailed in the tutorial.
This done I can get the netlist of the .subckt , the main schematic , the BOM: all looks good.
But when I try to simulate the project I get the error: "Error: unknown subckt".
I can notice that the subckt netlist in not in the project netlist.
Am I supposed to put the sub-circuit in a particular library or provide spice with the reference to my library?
There is no detail about this point in the tutorial.
I can share the schematics if needed since this is just an exercise example.
Thank you in advance for your support.
BR,
Patrice