Hi
I am trying make my first Board. and are meeting a lot of problems that might be easy to fix. as I don't know EASY EDA and my first project.
This is a Simple diagram like a household 3 way switch to turn on 1 bulb. .... (they are just interconnected).
But it can be cooked down to small problems.
![4-way switches position 2 uni.svg](https://upload.wikimedia.org/wikipedia/commons/thumb/f/f8/4-way_switches_position_2_uni.svg/1920px-4-way_switches_position_2_uni.svg.png)
I have seen a lot of tutorials, but they are all with lot more complicated diagrams, and doesn't help me.
I just started of by making the bord layout and it should be easy
it is not fully connected and the switch is a 3pdt switch
![image.png](//image.easyeda.com/pullimage/cR0PTmECDxSbJp2TNwi2jANppJMDW0KqoV3RutzX.png)
![buffers](http://www.kobra.hr/Schematics/Buffers%20Switchers%20Mixers%20and%20Routers/3PDT%20LED%20wiring.gif)
![image.png](//image.easyeda.com/pullimage/CzHoWMqrj4lxYgz1dHD5au7ttZAicmF3gN94GfiR.png)
but then we are getting the blue lines, that as I understand, it says that I need to add a wire and connect these pins, but I didn't ask for this.
then someone said that I needed a diagram that I could convert to a PCB board.
so here it is:
![image.png](//image.easyeda.com/pullimage/tCnr0TBmO3oCRs49wFPnDJL0e2JcXke5AjrJzEgn.png)
but when I try to convert it I get a lot of net errors. I have tried VCC, +5, -5, GND in both ends of the wires .. and nothing seams to Work and not getting errors even if I make the diagram super simple like below
![image.png](//image.easyeda.com/pullimage/qBhO56M7vSAt9JZzw6qsG1SDf0pX1O9rRO4VZkiA.png)
![image.png](//image.easyeda.com/pullimage/7Ti9dPdqeUMoOjc5JHhWalueCXdwtHiApM6auTYc.png)
Can anyone help a me as I am trying to learn the program and electrical board making.
kind Regards