@Ozzyoz, I strongly recommend that you stop what you are doing and take several steps back otherwise you will probably waste your money on a non-working PCB and may well end up with something dangerous. Sorry but your PCB is so full of errors it is almost impossible to debug. It would take far to long for anyone to check it and without a schematic to work from it is utterly useless to try. A quick look is enough to show that you have either not read the Tutorial or have not understood parts of it. If you want to design a PCB using EasyEDA then please read the Tutorial and follow the Design Flow. Do not just launch into drawing a PCB by trying to use EasyEDA as a drawing package. If you really must design the PCB without a schematic then you must read: [https://easyeda\.com/forum/topic/How\_does\_the\_Connect\_Pad\_to\_Pad\_tool\_work\_\-JgQO0Ay7H](https://easyeda.com/forum/topic/How_does_the_Connect_Pad_to_Pad_tool_work_-JgQO0Ay7H) I recommend you read: [https://easyeda\.com/andyfierman/Welcome\_to\_EasyEDA\-31e1288f882e49e582699b8eb7fe9b1f](https://easyeda.com/andyfierman/Welcome_to_EasyEDA-31e1288f882e49e582699b8eb7fe9b1f) Since you are working with valves/tubes, you may have to create your own symbols. Please also see: [https://easyeda.com/forum/topic/How-to-create-findable-footprints-and-searchable-symbols-69935f0358254dab92a9386190bcc35a](https://easyeda.com/forum/topic/How-to-create-findable-footprints-and-searchable-symbols-69935f0358254dab92a9386190bcc35a) You also need to read up on the recommended clearances around high voltage tracks and pads. There are several free online tools that you can use for this. This is an excellent starting place: [https://www.smps.us/pcbtracespacing.html](https://www.smps.us/pcbtracespacing.html)