I'm very close to ordering my first PCB. The silkscreen layer in the PCB Library for two connectors and an ESP-8266 based module extend past the edges of the board. (Up to 200 mils in the case of the ESP-8266 module.) The finished board fits in an area that is 4700 mils x 2400 mils. (120 mm x 61 mm) With the full silkscreen, the dimensions are approximately 4800 x 2500 mils (123 mm x 65 mm) Questions: 1) Should I modify the part packages to remove the silkscreen that extend past the board? 2) If I don't modify the silkscreen, when I go to order the board, do I put in the final board dimensions or the dimensions that include the full silkscreen layer? Thanks in Advance- David Nichols