[https://easyeda.com/forum/topic/Single-side-PCB-d9135efb960a4a97934f584a4cb767e9](https://easyeda.com/forum/topic/Single-side-PCB-d9135efb960a4a97934f584a4cb767e9)

OK good,   the manual says that only one side is used to delete what is needed from the zip file. but I want to use both sides of the board, parts that solder on one side copper only on one side! Is it possible to create this type of pcb?  I'm trying to get used to easyeda so far this problem confuses me the most.

Removing pads the way you are suggesting is not normal practice and will compromise the reliability of your pcb. Just design it as a conventional double sided pcb. Mount the components on the top side and solder them on the bottom side.

ok as far as i understand there is no such option, sad because the program is perspective but without this option there will be no work. I consider such an option to be vital because if i need  to re-solder the element it would be difficult to do when the element is soldered on both sides..

You do not solder it both sides. You only solder it on the pin side. If you have trouble desoldering then you need to (i) buy some desoldering braid and (ii) buy a good quality soldering iron.