Your screenshot shows an error message which hides much of what may have otherwise been a useful image. Your project is private so only you can see it. Please read the topic marked as [Must read]: [https://easyeda.com/forum/topic/How-to-ask-for-help-and-get-an-answer-71b17a40d15442349eaecbfae083e46a](https://easyeda.com/forum/topic/How-to-ask-for-help-and-get-an-answer-71b17a40d15442349eaecbfae083e46a) and in particular read the Simulation Tutorial in those linked documents. Then post back with the link to a public project if you have more questions. Thanks.

Please take note of the prelimiary remarks in the Simulation Tutorial about where to find spice symbols. If you replace R6 with a pot from the EELib (in Sim mode), your sim will run. You will however have to  try a combination of putting on specific voltage probes, running it for a shorter time than 10m and try using the Start Time (time to start plotting results) parameter in the CTRL+J simulation setup to try to reduce the amount of data being generated by the sim. :)