This is my first attempt at using EasyEDA. I have created the schematic and then the PCB layout. I would be quite happy with a single sided board. I am using through hole components including DIL packages. Can I assume that the red TOP layer tracks will correctly align with the DIL pins, ie. the DIL packages will be on one side of the board and the copper tracks will be on the other side and will be correctly aligned with the DIL pins. I have included solder pads and have used the blue layer to show the location of wires that will cross over the copper track where cross-overs are needed. The wires will be on the same side of the board as the components.