**BUG** Concise problem statement: When using the Photo Viewer, any holes that are located in a pad appear underneath the pad. Steps to reproduce bug: 1. Place an SMD component or Pad on top layer with no hole. 2. Place a via in the pad. 3. View the PCB in the Photo Viewer. 4. Compare top and bottom layers. Results: Via will be shown in the bottom view, but not the top view. Expected results: I would expect the top view of the PCB to show a hole/via in the pad. (I'm guessing this isn't intended behavior since I would think a manufactured board would have a hole in the pad.) Browser: Chrome You can see in this picture I have placed a bunch of vias in pad, but they appear to be rendered underneath the pad since I can see the vias on the edges that aren't entirely inside the pad. ![Vias under pads][1] [1]: /editor/20150701/5592cbaaa4dc9.png