If you just want DC voltages in a circuit where the initial conditions are the same as the final state that you want to measure then you can run a .op Analysis. The voltages will not display on the schematic but they can be opened in the Show simulation report button. Please see the section on Analyses in the Simulation Tutorial, (3) in (2) in: [https://easyeda.com/forum/topic/How-to-ask-for-help-and-get-an-answer-71b17a40d15442349eaecbfae083e46a](https://easyeda.com/forum/topic/How-to-ask-for-help-and-get-an-answer-71b17a40d15442349eaecbfae083e46a)