There seems to be something strange happening when I make a new board outline. 1\. I delete the board outline then go to 'Tools/Set board outline'\. 2\. I select Rectangular and click 'Apply'\. 3\. I select the left hand edge of the outline and drag to the right\. I notice the top left hand corner shows 3 dots and a spurious line pointing left! See Board-outline-#2 4\. I then select the top edge of the board and drag upwards\. The top left hand corner now has a piece jutting out to the left! See Board-outline-#2 5\. This phenomena does not happen if I move the bottom edge or right hand edge! Deleting nodes in the boarder outline disconnects the board outline and the autorouter does not like it. I can not find out how to reconnect the board outline when it becomes disconnected so that the Autorouter will work. Please also see my Public YT video: [EasyEDA border problem](https://youtu.be/zuFFEpeLXhI) This shows the problem in exquisite detail. This video also shows that after some manipulations **some** of the border freezes and can not be dragged at all!