This is PROBABLABLY a operator error but I can't figure it out. I have a small 4 layer PCB design, with plane on inner 1 and inner 2.   all signals are on top and bottom. in EASYEDA,  LAYER MANAGER inner1 and inner 2 are Check and type as PLANE                         on the LAYER and OBJECTS -- I see both, INNER1 and INNER2                         When I look directly at the layers, I see the correct "thermal" connections.                         When I do GENERATE GERBERS- is says 4 LAYERS BUT when I get to the JLCPCB Order                          It initially says 4 layers                          then loads GERBER file goes to 2 layers                          If I load a stored Gerber file (of the same design) it also says 2  layers SO,  some how when I generate Gerbers it is ONLY doing 2 layers !!! Why ????