Hi all\, I'm some way through my latest design and have during the process have deleted and relaced some components to make things fit onto the board\.I need to assign a specific design rule to some of the nets so the have greater spacing and wider track\. So far so good\, however when I open the Design Rule dialog box some nets are missing from the list\. Oddly there is a 5 pin connector\, J2 with pins labeled 1 to 5 and only pin J\_1 is in the net list\, where are pins J\_2 to J\_5 Edit, Panic over, I found them labelled by the component at the other end of the net. Doh!