What is your problem?

We want to make it better and better.

Can you tell us which part is unusable?

I found out you use  browser is IE Edge/17.17134 , Can you give Chrome or our desktop version a try?  [https://easyeda.com/page/download](https://easyeda.com/page/download)

thanks for the quick response. problems: 1\. I can place components and save consistently\, but when I go back into a project half of them will be missing\. Although the tracks to them will still be there\. 2\. for the last day I haven't been able to run bottom layer tracks\, or I can run 1 track and then cant run anymore\. Even though it shows the white outline like it does on the top layer\. 3\. When running tracks it tends to not want to connect to the pad and you have to zoom in and drag it on to the pad\, where as before it would automatically connect\. Thanks

ok, I will download it and give it a try Thanks

@Potto  , IE is the worst browser, We don't test under IE  EasyEDA just support Chrome, Firefox, and desktop version. Can't promise to work under IE. Chrome is the best, do give it a try , then lets us know. I found out you use  browser is IE Edge/17.17134 , Can you give Chrome or our desktop version a try?  [https://easyeda.com/page/download](https://easyeda.com/page/download)

ok I'm downloading it now fingers crossed, thanks for your help

@Potto, I'm developing various PCBs, and switched to the new version a few days ago - no problems! I am using Chrome. Hope this helps. rudi

Yep that works a lot better now, I will say that it still does not automatically run the track to the pad, around half the time it stops short and you need to drag it on to the pad. Thanks for the help

@Potto you can change the routing conflict to ignore at the right-hand panel.

in pad properties?

PCB properties