I have installed the local Router, and want to autoroute the PCB, but fails by unknown reason.
After running "auto router config" the message "not a valid PCB, please check it again". There is no hint were to look for.
Any ideas?
I have installed the local Router, and want to autoroute the PCB, but fails by unknown reason.
After running "auto router config" the message "not a valid PCB, please check it again". There is no hint were to look for.
Any ideas?
Thank you. Indeed, this was the problem. Was already searching for hours
Kind regards
Marcel
Brand new interactions and interfaces. 
Easy to use and quick to get started. 
Your board outline is not closed.
You can draw a board outline using individual lines but the each end point of each line must be exactly coincident with the end point of each adjacent line.