HELLO EVERYONE, I'M NEW TO DESIGNING, BUT I WANT TO FIGURE OUT IF IT'S NOT POSSIBLE TO MEASURE THE SIGNAL FROM PIEZOELECTRIC ELEMENTS, I THINK THE PROBLEM IS CONNECTING THE OPERATIONAL AMPLIFIER AND STRAPPING IT. TELL ME IF THE NODES ARE DESIGNED CORRECTLY.THE IDEA IS TO USE PIEZOELECTRIC ELEMENTS AS A SHOCK SENSOR
These may help too:
https://www.allaboutcircuits.com/technical-articles/understanding-and-implementing-charge-amplifiers-for-piezoelectric-sensor-s/
https://www.allaboutcircuits.com/technical-articles/how-to-design-charge-amplifiers-piezoelectric-sensors/
https://www.ti.com/lit/an/sloa033a/sloa033a.pdf
Brand new interactions and interfaces. 
Easy to use and quick to get started. 
Your schematic snippet is incomplete and gives no information about the type of piezo transducer that you wish to interface to.
Please read:
https://easyeda.com/forum/topic/How-to-ask-for-help-and-get-an-answer-71b17a40d15442349eaecbfae083e46a
https://en.wikipedia.org/wiki/Piezoelectric_sensor
https://en.wikipedia.org/wiki/Charge_amplifier
and:
https://www.digikey.co.uk/en/articles/fundamentals-of-piezoelectric-shock-and-vibration-sensors