Good day everyone, i'm struggeling to design a touch pad/button. i'm trying to design a touchpad with graphics integrated. the following happens everytime. if i'm using a pad in pcb designer, i dont get a soldermask on top. if i'm designing one with images, i'm not getting it to connect to my net/pin. is there a way to make a pad from image? if yes is there a way to put soldermask on top? of course not using solit, this will take to long for my design. my goal to achieve is: if i make a touch button. i don't want copper to be exposed(obvious reason statics). and i want to have a image inside of the pad where there is no copper nor solder mask. i did read a lot of forum post, watched tutorials. but i cant seem te find a solution. can someone give me a direction to look for? thank you