Hi ,everyone,
I designed a two-layer pcb, using via to connect top gnd layer to bottom layer. But it display different in different PCB area as shown below. Does any one can help figure it out? The left figure is the pcb view in easyEDA, the right figure is the gerber view
Thanks any help in advance
![question.jpg](//image.easyeda.com/pullimage/F86F8B1Zmlme1R3KrLfAyFxmvcsaP5WggEuYLsa5.jpeg)![question1.jpg](//image.easyeda.com/pullimage/CPcPCaMc6dVp3Q3mdQDxTXgirWy8ac3lGcSLZ2zO.jpeg)
Firefox
59.0
Windows
10
EasyEDA
5.4.11