Hello!
In high frequency boards and or RF boards it is common policy to pour a copper groundplane on the top and the bottom layer. These layers are then connected with eachother by numerous vias providing a good ground plae for both layers.
Is there a good way to do this in EasyEDA. In kicad I would start from a GND point and move the cursor by 100mils and press V, but This doesnot work here. Any suggestions please?
Thank you!
Graat
Solved it! The via settings, including the Net (GND) is remembered so stitching is easy. Just drop vias were you want them.
Chrome
61.0.3163.100
Linux
EasyEDA
5.8.20