First timer first schematic advice and feedback please
posted by jasemilly , 1 month ago.
replied by andyfierman , 1 month ago.
DRC errors introduced by new version of EasyEDA
posted by mkkrasus , 1 month ago.
replied by UserSupport , 1 month ago.
Too many users in simulation. Please try again later
posted by dalacort , 1 month ago.
replied by andyfierman , 1 month ago.
How to customize paste mask layer to prevent stencil from having holes for jumper pads
posted by John Kougoulos , 1 month ago.
replied by UserSupport , 1 month ago.
Inconsistent handling of illegal characters.
posted by andyfierman , 2 months ago.
replied by andyfierman , 1 month ago.
Annotation when placing 2 of the same module
posted by Ahiad , 2 months ago.
replied by UserSupport , 1 month ago.
My trace from a part to a pad is putting the trace inside the hole of the pad.
posted by Joseph Massimino , 2 months ago.
replied by UserSupport , 1 month ago.
PCB Edge fingers for M.2
posted by eric.baril.31 , 2 months ago.
replied by andyfierman , 2 months ago.
Ordering 1.0mm PCBs does not transfer gerbers to JLPCB
posted by terryjmyers , 2 months ago.
replied by UserSupport , 2 months ago.
How to arrange rateline without overlapping?
posted by forzaelectronica , 2 months ago.
replied by forzaelectronica , 2 months ago.
JLCPCB Gerber Viewer not accepting EasyEDA Gerber zips
posted by andyfierman , 2 months ago.
replied by andyfierman , 2 months ago.
Copper Area missing settings
posted by butmalai.dan , 2 months ago.
replied by UserSupport , 2 months ago.
Copy/Pasting without changing prefixes?
posted by gamerpaddy , 2 months ago.
replied by UserSupport , 2 months ago.
Update PCB fails to report footprint changes
posted by NuttyProfessor47 , 2 months ago.
replied by NuttyProfessor47 , 2 months ago.
Copper areas with shared edges do not respect clearances
posted by andyfierman , 1 year ago.
replied by andyfierman , 2 months ago.
PCB Layout Autoroute measurement in "milli-meters"
posted by hariharan3493 , 2 months ago.
replied by hariharan3493 , 2 months ago.
